Radio Shack Realistic PRO-2030 - Scanning the Channels

LISTENING TO MONITOR MEMORIES
You can listen to monitor memories by pressing MAN, MON, and then the number for the monitor
memory you want to listen to.
Moving A Frequency From A Monitor Memory To A Channel
Follow these steps to move a frequency from a monitor memory to a channel.
1. Press MAN. Enter the channel number you want to store the monitor frequency into, then press
PGM.
2. Press MON and enter the monitor memory number that has the frequency you want to store.
3. Press ENTER. The scanner stores the monitor frequency into the channel.
Note: If you want to return to a limit search after this procedure, press LIMIT and either /\ or \/
to continue.
SCANNING THE CHANNELS
To begin scanning the channels in your scanner, press SCAN. The scanner scans through all non-
locked channels (see "Locking Out Channels" in SPECIAL FEATURES). Set SQUELCH so you do
not hear the hissing sound between transmissions.
SPECIAL FEATURES
DELAY
Many agencies use a two-way radio system that might have a period of several seconds between a
query and a reply. To program a delay into that channel to keep from missing a reply, select the
channel and press DLY so DELAY appears on the display. The scanner pauses for 2 seconds on a
channel programmed with a delay.
When your scanner pauses at an active channel which has been programmed with a delay, it waits two
seconds after the completion of each transmission on that channel before it resumes scanning.