Radio Shack TRC-232 - Scanning Incoming Signals; Alternating between Two Channels

24
Scanning Incoming Signals
To scan incoming signals, press
SCAN
.
SCAN
appears on the
display, and the walkie-talkie stops for 5 seconds on each chan-
nel where there is a transmission. Press
SCAN
again to stop au-
tomatic scanning.
SCAN
disappears from the display.
Alternating Between Two Channels
To alternate between two channels, select one channel and
press
DW
(dual watch).
DW
appears on the display. Using the
UP
or
DWN
channel buttons, select another channel.
21-1672.fm Page 24 Thursday, August 5, 1999 12:04 PM