Radioddity GC-5 Series - Band, Channel, and Mode Selection

12
4.3 Status Indications
The status LED has a very simple and traditional design.
LED Indicator
Radio Status
Constant Red
Transmitting.
Constant Green
Receiving.
4.4 Main keypad controls
• Side key 1 (Flashlight and Alarm)
Press [SK1] key momentarily to turn on the LED flashlight. Another momentary press will flash the LED. Another momentary
press turns the flashlight off.
Press and hold [SK1] key to activate the alarm function. Press [SK1] (a short press) again to turn it off
• Side key 2 (Broadcast FM and Monitor)
Press [SK2] key momentarily to start the broadcast FM receiver. Another momentary press turns the broadcast FM receiver
off. If a signal is received on the active frequency or channel while you are listening to the broadcast FM, the receiver will
open a squelch to that frequency (as if scanning) and remain there until the signal goes away; it will then switch back to
broadcast FM.
Press and hold [SK2] to monitor the signal. This will open up the squelch so you can listen to the unfiltered signal.
•
key
It is used for activating the MENU, choosing each MENU selection and confirming the parameter.
•  key: Press it for more than 2 seconds, the channel and frequency will move upwards rapidly; in SCAN mode, press this
control to move the scanning upwards.
•  key: Keep it pressed it for more than 2 seconds, the channel and frequency will move downwards rapidly; in SCAN mode,
press this control to move the scanning downwards.
•
key
Press to exit the Menu and functions.
Press and hold the
key to activate the one-touch search function.