Fault-nding
The RD7000 TL and PL have the ability to detect cable faults accurately using an
accessory A-Frame. Fault-nding works by detecting signal to ground bleeding caused
by damaged cable sheaths. For a detailed guide to fault-nding, please refer to the
RD7000 operation manual.
Service and Maintenance
Use eCAL™ to determine if your RD7000 receiver is still within its original factory
calibration settings. For more information visit www.radiodetection.com
The receiver and transmitter are designed so that they do not require regular calibration.
However, as with all safety equipment, it is recommended that they are serviced at least
once a year either at Radiodetection or an approved repair center.
Radiodetection products, including this user guide, are under continuous development
and are subject to change without notice. Go to www.radiodetection.com or contact
your local Radiodetection representative for the latest information regarding the RD7000
or any Radiodetection product.
To Next Page
Loading...
Need help?
General
