What to do if Radiodetection rd7000+ Measuring Instruments shows Bluetooth error BT005?
If you are seeing Bluetooth error BT005 on your Radiodetection Measuring Instruments, the paired connection attempt may have failed. Power cycling might be required.
What does Bluetooth error BT004 mean on Radiodetection Measuring Instruments?
Bluetooth error BT004 on your Radiodetection Measuring Instruments indicates that the locator is not paired with the PDA.
General| Passive Avoidance Modes | Yes |
|---|---|
| Ingress Protection | IP54 |
| Display | LCD with backlight |
| Depth Accuracy | ±5% of depth reading |
| Current Measurement Accuracy | ± 5% of reading |
Details critical safety precautions for operating the equipment.
Describes SideStepauto for optimizing frequency based on ground impedance.
Using the transmitter's measure mode for impedance and voltage.
Details on Peak, Null, and Combined Peak/Null antenna modes.
Procedures for accurately pinpointing the location of a target line.
Methods for locating unknown lines in an area.
How to enter and use the marker mode to locate RF markers.
Procedures for single mode and combined mode locating of RF markers.
Explains the automatic depth measurement feature.
Techniques for checking the accuracy of depth readings.
How to measure and interpret current readings on utilities.
Describes how current measurements are taken and their significance.
Taking current measurements for signal verification.
Techniques for applying signals to long pipes or those with insulated joints.
Introduction to using sondes for locating pipes, ducts, and drains.
Using a submersible antenna for tracing lines underwater.
Introduction to locating cable sheath faults and insulation damage.
Steps to prepare for a fault-finding survey, including reference readings.
Procedures for locating faults using the A-frame and locator.
Guidance on resolving common Bluetooth connection issues and error codes.
Technical specifications for the RD7000+ system.
To Next Page
