Need help?Do you have a question about the Radiodetection RD4000T10 and is the answer not in the manual?
General| Brand | Radiodetection |
|---|---|
| Model | RD4000T10 |
| Category | Measuring Instruments |
| Language | English |
Detailed description of the RD4000 receiver's interface elements and controls.
Instructions for powering the T3/T3F transmitters and selecting operating frequencies.
Instructions for powering the T10 transmitter and selecting operating frequencies.
Instructions for fitting alkaline and rechargeable batteries into the receiver.
Details on internal alkaline, rechargeable, and external power sources for transmitters.
How to switch the receiver on/off and check its battery status.
Instructions for running the receiver's diagnostic self-test procedure.
How to choose operating frequencies and bandwidth modes for locating.
How to use the null response for precise line identification.
Guidelines and precautions for obtaining accurate depth measurements.
Methods to verify the accuracy of depth readings.
Two field procedures for verifying depth calibration accuracy.
Explanation of how current measurement aids line identification.
Procedure for performing current measurements on a target line.
Explanation of the CD feature for positive line identification.
Steps for setting CD frequencies on the transmitter and receiver.
Steps required to reset the CD reference for accurate readings.
Setup steps for locating cable sheath faults using the A-frame.
Confirming faults by using the VΩ function on the T10 transmitter.
Configuration steps for setting transmitters to FaultFind mode.
Procedure for obtaining a baseline reading for fault finding.
Steps for locating faults along a cable route.
How to activate the Electronic Marker System (EMS) function.
Activating the FaultFind mode on the T10 transmitter.
Techniques for finding and tracing the position of a sonde.
Precautions and requirements for working with live cables.
To Next Page