RD4000 Locating System User Manual
Page 13
How to use the web enabling features
• Lift up the dust cover (marked RS232) on the receiver, or remove the dust cover from the RS232 connector on
the T10 transmitter and plug the male end of the supplied RS232 communication lead into the RS232 socket.
• Plug the female end of the cable into the serial port, (normally COM 1) of the computer.
• Switch on the computer and receiver or transmitter, access the Internet and in the address bar type:
http://engineering.radiodetection.com. You will also find a link to this site at Radiodetection.com.
Once you are connected to the website, follow the on-line instructions for using the site.
Data logging
During a survey, depth and current can be logged from the RD4000 receiver to an external data logger for later
analysis. Data is presented to the RS232 socket after the depth button is pressed and after the auto timeout
period returns the locator to locate mode.
To Next Page
Loading...
Need help?
General
