RadioLink AT9 - Page 18

17
model name. Accordingly, if you want to change the model type, the whole data need to reset, also for model
name. The first thing to copy is to change the model type or delete the original name and rename a new model to
avoid confusion.
Model Name
This is used to set the present model name. Name all model to identify each other, and fast select the model
type and reduce possible crash by wrong model type using.
Format to name a model:
•the name can be more than 9 characters
•every character can be letter, number, blank or special characters
•factory setting name MODEL-XXXX will be shown as (example model 1 display MODEL-0001)
Goals
Steps
Inputs
Name
model3
“Cap-232_”
(where
underline
represents a
blank space
Open Model
for 1second.(If ADVANCE, again)
to MODEL SEL. Press PUSH
Confirm correct model
(Ex:3)
If select doesn’t show ‘3’,perform Model
select
Go to Name to change the
first character(Ex:M to C)
M to C,press PUSH.
Change the next character
to choose character,press PUSH to
confirm
Repeat the prior steps until
finish naming model.
to a .Repeat.
Colse
Sub-menu select: All parameters need one time setting. After the model type selected, you need to set the related
data for it.
•what is the model type
•whether the throttle channel 3 is right for the selected model type? Or you need to make sure channel 3 is of full
range adjustable (glider only). Also to different model, you can set by throttle reverse correspondently.
Initialize the original data first, and set new data for the selected model type
Model reset: model reset is available in factory only. If you want to delete a new set model type, you need to
delete one by one.
Goals
Steps
Inputs
Reset model
memory 1
Confirm you’re currently using
the proper model memory(Ex:1)
On home screen,check model name and No.
on topleft,if not conrrect use Model Select.
Open PARAMETER submenu
for 1second to Model SEL,Push.
Reset the memory
Push, to Model 1,PUSH
Confirm the change
Are you sure? Press PUSH
Close
Model type select
•aero basic:
Driving aero basic type (multi airfoil. Detail in Twin Aileron Servos, Twin Elevator Servos, Elev-flap mix and
V-tail)
•glider:
Different tail type (detail in glider type)
•helicopter:
8 swash plate types (detail in helicopter type)
caution: decide a model type for the model plane. To most fixed wing plane, aero basic is better, because it has
some function glider doesn’t have. While sometimes, glider (2A+1F) is better.