RadioLink AT9 - Aircraft Advance Menu Functions

79
6.1.2 AUX Channel setting
AUX channel for aircraft is channel 6 to 10, same like ACRO, GLID and HELI, to set auxiliary channel.
CH5 is special for ATTITUDE, enter CH5 and press PUSH for ATTITUDE. Select 3-section and 2-section
switch to get 6 different attitudes. By DIAL set 6 different rates according to the attitudes.
6.2 ADVANCE MENU FOR AIRCRAFT
6.2.1 ATTITUDE
There are 6 different attitude modes for aircraft: NORMAL, ATTI, GPS, HOVER, F/S and AUX. Every
mode will have a different rate to get a unique signal. NORMAL mode preset 0%, ATTI 50%, GPS 100%,
HOVER 25%, F/S 75% and AUX 50%.
0% means a output signal 1ms, and 100% means 2ms. You can totally get 6 different modes by adjusting the
related rates.
Goals Steps Inputs
Set the
ATTITUDE of
aircraft.
In ADVANCE menu find the
ATTITUDE function.
urn on the transimitter, for 1 sec. to BASIC
menu (If ADVANCE, again)
to ATTITUDE
Assign the switch to control
attitude.Ex: SW3 is SWC，SW2 is
SWB
to SW3, ， to SWC，
to SW2, ， to SWB，
Set the rate in each attitude.
Ex: ATTI is 60%.
to rate-ATTI, ， to 60%，
Close
6.2.2 THROTTLE CURVE (see ACRO 3.3.14)
6.2.3 PROG. MIX (see ACRO 3.3.1)