direction may be changed.
• multiple channels may be assigned to the same switch, slider or knob;
• channels set to "NULL" are only controlled by mixes. (Ex: utilizing 2 channels
for 2 rudder servos. See mixes, p. 68.)
• If GYRO SENSE, GOVERNOR, and THR-NEEDLE functions are activated, AUX-CH settings of related
channels become invalid automatically.
【
AUX-CH
】
CH5：SwG
CH6：VrA
CH7：VrC
CH8
：
VrB
CH9
：
SwB
CH10：SwA
Related channels:
GYRO SENSE (ACRO): ch. 5, 7, or 8
GYRO SENSE (HELI): ch. 5
GOVERNOR (HELI): ch. 7, or ch. 7 and 8
THR-NEEDLE (ACRO HELI): ch. 8
Remember that if you assign primary control of a channel to a switch which you later use for other
functions (like dual/triple rates or airbrakes), every time you use that other function you will also be moving
the auxiliary channel.
Goals Steps Inputs
Assign flaps to the right
slider[VR(E)] and set
channel 7 to NULL in
preparationto use it as a
smoke system control
(the smoke system being
activated later by a
throttle to CH7 MIX).
Open BASIC menu,then to
AUX-CH
for 1s .(If ADVANCE again) .
to AUX-CH,PUSH
Choose channel to change (Ex:CH6)
to CH6，PUSH， to desired
switch,PUSH
Repeat above steps as desired.
(Ex:CH7=NULL)
to CH7,PUSH, to NUL
Close
2.3.12 TIMER submenu (stopwatch functions):
Controls three electronic clocks used to keep track of time remaining in a competition time allowed, flying
time on a tank of fuel, amount of time on a battery, etc.
【TIMER】
<1>OFF <2>OFF
To Next Page
Loading...