Need help?Do you have a question about the RadioLink AT9 and is the answer not in the manual?
General| Frequency | 2.4GHz |
|---|---|
| Channels | 9 |
| Output Signal | SBUS |
| RF Power | <100mW |
| Dimensions | 100 x 180mm |
| Compatible Receivers | R9D, R6DS |
Explains the AT9 system's capabilities, functions, and key features.
Provides instructions for installing the receiver, servos, and antenna.
Covers initial configuration including model type, binding, and display settings.
Offers quick guides for ACRO basic menu and 4-channel airplane setup.
Covers model setup, type selection, trims, endpoints, and servo reversing.
Details D/R, Throttle Cut, Idle Down, Fail Safe, Aux Channels, Timer, Trainer, and Telemetry.
Discusses basic wing types (Simple, Twin Aileron, Tail-less) and tail types (Dual Elevator, V-Tail).
Explains mix types (Linear, Curve, Offset, Delay) and their applications.
Details Snap Rolls, V-Tail, Gyro Sense, Throttle Delay, Curve, and Needle settings.
Covers basic setup, model type selection, and trims for gliders.
Details wing control mixes like Flaperon, Camber, Elev-Flap, and Butterfly.
Covers V-Tail, Offset, Start Delay, and other tail/condition adjustments.
Covers initial helicopter setup, controls, and model type selection.
Details swash plate types and Swash AFR adjustments for helicopter control.
Covers pitch/throttle curves, revo mix, gyro, throttle hold, governors, and offsets.
Covers basic setup for aircraft, including model type and AUX channel configuration.
Details advanced aircraft functions, focusing on Attitude settings.
To Next Page