4.3.5 START DELAY (GLID 1A+1F only):
START DELAY automatically switch the offset trims (OFFSET) from the START condition's trims to the
normal condition’s trims after proceeding the delay time (max.10sec.) which is set by the -dly- item when
activating the START condition. (It is convenient for hand launch glider.)
Note: The same delay amount for elevator and rudder is recommended when using V-tail function.
ADJUSTABILITY:
• Delay time (-dly-) range of 0 to 100%. The delay time is 10 second at 100%.
Goals Steps Inputs
Ex: delay time=5
second.
Open ADVANCE
menu,then open START
DELAY.
to BASIC . again to ADVANCE
to START-DLY,
Activate the function
to MIX ， to OFF or ON
Set the delay time.
(Ex:50% each surface)
to ELEV ， to 50%
to RUDD ， to 50%
Repeat as needed.
Close
4.3.6 CHAMBER-FLP
CAMBER FLAP assigns the primary flap control [defaults to VR(A)] to allow trimming in flight of the flap
action. The up and down travel of each flap (camber flaps: FLP1/2) can be adjusted independently. Also the
center position of flap servo can be offset.
Note: If FLAP-TRIM is activated, you can not use CAMBER FLAP function simultaneously.
ADJUSTABILITY
•
Rate: -100% to +100%, with a default of +30%
• Center position (CENTER): The operation reference point of flap can be offset. -100% to +100%, with a
default of 0%.
To Next Page
Loading...