RadioLink AT9 - Flaperon (ACRO;GLID 1 A+1 F )

38
• ACRO/GLID Defaults: The 4 programmable curves mixes default to the most frequent choices, but can be
set to any channel.
• PROG.MIX5 rudder-to-aileron for roll coupling compensation (GLID mixes default to aileron-to-elev.)
• PROG.MIX6 rudder-to-aileron for roll coupling compensation (GLID mixes default to aileron-to-elev.)
• PROG.MIX7 rudder-to-elevator for pitch coupling compensation (GLID mixes default to
elevator-to-airbrake.)
• PROG.MIX8 rudder-to-elevator for pitch coupling compensation (GLID mixes default to
elevator-to-airbrake.)
• HELI Defaults:
• PROG.MIX5 aileron-to-elevator for coordinated turns
• PROG.MIX6 aileron-to-elevator for coordinated turns
• Master: The controlling channel can only be a channel. Cannot OFFSET or dial.
• Trim: not available in curve mixes.
• Offset: not available in curve mixes.
Goals
Steps
Inputs
Set up a RUDD-ELEV curve
mix on a model that pitches
down severely at full rudder
and not at all with minimal
rudder input, and pitches worse
on right rudder than left:
Point 1: 25%
Point 2: 8%
Point 3: 0%
Point 4: 10%
Point 5: 28%
ON
when SWITCHC is down.
LINK
should be
ON
if model
has twin e l evato r servos.
Ot h e rw i se ,
LIN K
remains
OFF
.
(Note that point 3 is 0%.
Otherwise,the elevator would
be retrimmed when the mix is
active and no rudder input is
given.)
Open an unused programmable
mix.(Ex: use PROG.MIX7 since
it is already set up for
FLAP-ELEVATOR)
to BASIC menu, again to
ADVANCE
to PROG.MIX PUSH 7，PUSH
Activate the function
to MIX，PUSH， to ON, PUSH
Choose master and slave
channels.
Already RUDD. Already ELEV
Set LINK as needed( Ex:off)
Assign SWITCH and position.
(Ex:change from F to C，Down)
to SW.PUSH. to C,PUSH
to POSI, PUSH. to DOWN
Optional: set switch to
STK-THR to activate mix with
THROTTLE STICK.
to POSI， Throttle Stick to desired
point .
Push 1sec.to set.
Optional: set switch position to
NULL.Make mix active at all
time.Not complete with
STK-THR.
to POSI, PUSH, to NULL
Set desired percent at five stick
points.
to POINT -1 to 25% ，
Repeat for points 2-5.
Close
3.3.3 Flaperon (ACRO/GLID 1A+1F ):
ACRO GLID