RadioLink Electronic Ltd
www.radiolink.com
Transmitter Phase Setup
If RadioLink transmitter is used, set transmitter phase:
CH3 - Throttle: Reversed
Other channels: Normal
Note: When using a non-RadioLink transmitter, there is no need to follow this requirement.
Transmitter Phase Test
Make sure the transmitter phases are correct before flight. All the settings will take Mode 2 as example.
Please check the transmitter phase at Manual Mode.
At Manual Mode, put the aircraft on the ground and keep horizontal. Check the phase of aileron, elevator,
and rudder by pushing the joysticks of transmitter.
Toggle the aileron joystick to left, left aileron is lifted and right one is pressed; toggle the joystick to right,
left aileron is pressed and right one is lifted.
Toggle the elevator joystick downward, elevator servo(horizontal tail) is lifted; toggle the joystick upward,
elevator servo(horizontal tail) is pressed.
To Next Page
Loading...
