12 Operation
1.
Set the frequency switch to the desired channel position (1-6).
2. Do not interrupt another user. Listen for activity on your
channel. If the channel on which your are transmitting is
programmed to receive PL and the squelch switch is in the
PL ( ) position, momentarily depress the monitor button to
listen for channel activity. The channel must be clear before
transmitting.
3. While holding the radio in a vertical position with the
speaker-microphone grille two to three inches from your
mouth, press the push-to-talk switch on the side of the radio
and speak slowly and clearly into the grille area. When
finished transmitting, release the push-to-talk switch to
receive.
1. When the push-to-talk switch is depressed, the red LED
turns on, remains on for the entire length of the
transmission, and turns off when the PTT switch is released.
2. Low Battery Check
When the push-to-talk switch is depressed (and as long as
the push-to-talk switch remains depressed), the battery
voltage is automatically monitored and if the voltage is low,
the red LED flashes to alert the user of the low battery
condition.
To Next Page
Loading...
