21Operation with Options (cont.)
To dial this sequence, depress and hold the PTT switch down,
press “*”, then press the proper memory location (1-9). The
access code will be transmitted followed by a pause. The pause
gives the system time to check the access code and send out a
dial tone. After you receive the dial tone, the phone number may
be dialed by holding the PTT switch down again and pressing any
digit (not “*” or “#”).
Continuous Tone DTMF
This option is identical to the standard DTMF option, except that
no memory features are available and the tones generated by the
depression of a keypad button are not of a fixed duration.
Instead, the tones will continue for as long as a button is
depressed.
DTMF with ANI
With this option installed in your radio, the memory contains pre-
stored telephone numbers and is not available for manual
storage or erasure of telephone numbers by the radio operator.
A special fixture is required for changing preprogrammed
numbers. The last number redial and automatic dialing features
are still functional.
DTMF with ANI is in a volatile memory. If the battery is
removed for more than two minutes, the programmed
information may be lost, and reprogramming with the
ANI fixture would be required.
Another transmission may be initiated immediately after releasing
the PTT switch by depressing the PTT switch again. If the PTT switch
is released before the 60 second time out, the radio operates as
normal (reverts to the receive mode with no alert tone).
To Next Page
Loading...
