13Operation with Standard Features
To fit your particular needs, a number of features are available to
enhance the operation of your P200 radio. These capability
features are described for you in this section.
Quik-Call II
The Quik-Call II provides the user with the talk-back pager feature.
As in a standard radio, when the unit is turned on, a short
power-up alert is generated. The radio then operates in the
carrier squelch mode as described in the basic operating
procedure. (Also during this power-up period, the Quik-Call
decoder is active and will emit an alert tone on detection of a
valid code.)
To put the radio in the Quik-Call II (paging) mode, set the squelch
select switch to the enable ( ) position, then momentarily
depress the monitor button. When paged, an interrupted alert
tone is generated, the radio is put in the carrier squelch mode
and the caller's message is heard.
The radio will remain in the carrier squelch mode for six seconds
after the loss of carrier. If the carrier is lost, but for less than six
seconds, an auto timer will reset, which permits normal transmit
and receive operation as described in the basic operating
procedure. If no transmission is made within six seconds, the
radio will automatically revert to the Quik-Call II (paging) mode.
To initiate a transmission (radio not paged), set the squelch
select switch to carrier squelch ( ) position. Then transmit and
receive as described in the basic operating procedure. The radio
does not automatically reset to the paging mode at the end of
the conversation. To reset the radio to the paging mode, set the
squelch select switch to the enable ( ) position and then
momentarily depress the monitor button.
To Next Page
Loading...
