38 Battery Chargers Operating Instructions (P200)
1. Plug the charger into the appropriate ac power outlet (see
“Kit Information” for the correct voltage for your charger kit
number).
2. Insert the battery, with or without the radio, into the charger
pocket (BE SURE THE RADIO IS TURNED OFF). When the
battery is fully inserted, the red charging light will turn on.
You can turn the radio on while it is in the charger and it
will receive normally. However, allow at least 25% more time for
the battery to reach full capacity. DO NOT TRANSMIT WHILE
THE RADIO IS IN THE CHARGER.
3. For Single-Unit and Multi-Unit Rapid-Charge Battery
Chargers only: When charging a rapid-charge battery, the
green CHARGE COMPLETE light will turn on when the
battery reaches full charge. When a standard-charge
battery reaches full charge, no change in the light will occur
(red light remains on). If both lights flash when the battery
is inserted in the charger, there is an open or short circuit
in the battery. Be sure both the charger and battery
contacts are clean.
To Next Page
Loading...
