Reactor-Ready - Lab Reactor
3. Safety Information
The following symbols are intended to assist the user in the safe and efficient operation of Reactor-Ready.
4. Important WARNINGS
• Please read these instructions completely before using your Reactor-Ready system.
• Always read the instructions of any third party equipment, such as overhead stirrers and thermoregulators thoroughly
to ensure you are not contravening any safety recommendations or manufacturers warranty when used
in conjunction with Reactor-Ready.
• Always ensure that the Reactor-Ready vessel is clamped and supported correctly, using the purpose built stand
and clamp. Under no circumstances should the system be operated without this stand.
• The maximum operating speed for Reactor-Ready is 500rpm for continuous operation and 800rpm for short periods.
• It is the responsibility of the user to ensure correct set up, and continued maintenance of the stand, clamps and framework.
• Always ensure that Reactor-Ready is located on a level surface.
• Operate only in a fumehood with protective safety sash.
• Risk of burns from hot or extreme cold during and after heating/cooling, therefore take care not to touch
the Reactor-Ready unit, or any of the auxiliary modules.
• Reactor-Ready unit will remain hot for some considerable time after the heating source has been switched off.
A temperature probe or temperature sensitive label can be used to indicate when components are too hot to touch.
• Before starting your reaction, ensure that all fittings to the thermoregulator are fully tightened and not leaking
and that the manifold drain and vent valves are closed.
• Reactor-Ready metal components are resistant to the majority of solvents and splash resistant
to dilute acids and alkalis at room temperature.
• Always wipe away any chemical spills immediately and avoid exposure to strong vapours such as HCL etc,
as continued exposure to chemical vapours or liquids will cause corrosion to metal and/or plastic components.
• Reactor-Ready can be used with a recirculating fluid at a temperature of up to 190˚C, or down to -60°C without
damage to the unit. Careful inspection of all fluid connections to Reactor-Ready should be regularly performed when
operating at these temperatures.
• Ensure all wires and cables connecting auxiliary equipment are secured such that they cannot come into
contact with Reactor Ready surfaces, or moving parts.
• Reactor-Ready should only be operated by trained and competent personnel. As with all chemistries, a full risk
assessment should be performed prior to starting, and care should be taken to monitor your reactions at all stages.
During operation Reactor-Ready should not be left unattended unless in a supervised area.
Page 3
Warning
Applies when there is a possibility
of personal injury.
Important Note
Alerts the user to important facts.
!
I
mportant, Important,
I
mportant, Important,
Important, Important,
Important, Important,
Important, Important,
Important, Important,
To Next Page
Loading...