Rage Super Cub MX - Aircraft Assembly; Battery Installation; Transmitter Details; Transmitter Battery Installation

5
Super Cub MX Assembly
TheSuperCubMXcomesnearlyready-to-y.Allthat
isrequiredtocompleteistheinstallaonofthe
landinggear.
Insertthelandinggearwireintotheslotattherear
ofthebaerybox.Thewheelsshouldberakedfor-
ward.Thelandinggearareheldinplacebyfricon,no
screwsarenecessarytoretain.
Battery Install
Insertthebaeryintothebaeryboxlocatedonthe
boomofthefuselage.First,turnonthetransmier
withthethroleo(letransmiersckalltheway
down).Thenplugintheconnector,whichwillpower
uptheaircra.Unplugtheightbaeryattheendof
eachight.
Transmitter Details
Throttle Stick
Elevator/Rudder
Stick
On/Off
Elevator Trim
Rudder TrimNot Used
Not Used
Antenna
Handle
PASS Switch
Power LED
PLEASE NOTE: Install 4 AA baeries into the
baery compartment located on the back of
the transmier, under the baery hatch cover.
Make sure that the baeries are installed with
correct polarity per the diagram inside the
baery compartment.
Install Transmitter Batteries