Rage Super Cub MX - Motor Arming Procedure; Control Functions Overview; Servo Reversing

6
Control Functions
TheSuperCubMXcomesnearlycompletelyassembled.Allthecontrolsurfaceshavebeen
pre-connected.Checkthatthedireconofmovementiscorrectforeachofthecontrolfunc-
ons.Thisisaccomplishedbyfirstturningonyourtransmier(makesurethatyourthrole
sckisattheboomposion)andthenplugginginyourcharged1-cellightbaery.Leavethe
throlesckinitsoposion.Themotorwillnotbeacvatedunlthethrolesckiscycled
fromtheboomtothetopandbacktotheboom.FlipthePASSswitchlocatedontheright
shoulderofthetransmierawayfromyou,intotheAssistOposion.Inthisposionthecon-
trolsurfaceswillonlymovewhenthescksonthetransmieraremoved.Withthetransmier
scksintheirneutralposionsthecontrolsurfacesontheaircrashouldbeneutral.
Throttle
Down
Throttle
Up
Arming the Motor
Thelesckonthetransmiercontrolsthethrolefuncon.Whenthetransmierisonand
theaircraightbaeryispluggedin,theelectronicswillbeacvebutthemotorwillnotbe
armed.Toarmthemotor,cyclethethrolesckfromtheOFFtotheONposionandthenback
toOFF.Youwillhearanarmingtoneandthenextmethatthethrolesckisraisedthemotor
willstart.
Innormalightoperaons,alwaysturnthetransmieronfirstandthenpoweruptheaircra.
Keeptheaircrasllfor3-5secondstoallowthegyrotoproperlycalibratebeforeying.Cycle
thethroleOFF/ON/OFFtoarmthemotor.Whenfinishedyingalwaysunplugtheight
baeryfirstandthenturnothetransmier.
Servo Reversing
Ifacontrolsurfaceismovinginthewrongdirecontheservosoperaonwillneedtobere-
versedelectronically.
Followthesestepstoreverseaservo:
• Turnonthetransmierandplugtheightbaeryintotheairplane.
• FlipthePASSswitchtoNoAssist(Switchtowardrearoftransmier).
• Donotarmthemotor.
• Holdthecontrolsckforthefunconthatyouwanttoreverseallthewayllitstops.
• Holdthecontrolsckinplaceunlyouseethecontrolsurfacechangedirecons-within
 3to5seconds.