Why are some stations not working on my Rain Bird RC-7A Controller?
If some stations aren't operating, it could be due to a couple of reasons. First, the station time might be set to OFF; in that case, set the TIME control for more than 3 minutes. Second, there might be faulty valve wiring. Check the connections between the controller and valves, and also inspect the valve actuators.
What to do if the clock stopped on my Rain Bird RC-7A?
If the clock has stopped, there are a couple of things to check: First, the circuit breaker might have tripped. Push the RESET button. If the controller stops again, inspect the system circuits to find the issue. Second, there might be no power to the controller. Check the line voltage and connections at each end.
Why won't my Rain Bird RC-7A Controller start automatically, even though the DAY and HOUR dials function?
If the DAY and HOUR dials are working but the cycle won't start automatically, the MODE switch might be in the wrong position. Move the switch to the AUTO position.
What to do if my Rain Bird Controller immediately restarts without stopping at the REST position?
If the controller restarts immediately without stopping in the REST position, it could be due to: 1. Insufficient cycle time allowed: Adjust the cycle time for more than 15 minutes. 2. Total cycle time coincides with a succeeding START pin: Reset the HOUR pins or readjust the accumulated cycle time.
How to fix DAY and HOUR dials if they function incorrectly on Rain Bird Controller?
If the DAY and HOUR dials are functioning incorrectly, it could be due to: * The clock is set for the incorrect time. Reset the clock for the 'present' time. * Pins are incorrectly set. Check pin settings and 'accumulated cycle time on station dial.
Why doesn't the station dial stop at a 'Timed' station on my Rain Bird Controller?
If the station dial isn't stopping at a 'Timed' station, the TIME control might be set for less than 3 minutes. Adjust the TIME control for more than 3 minutes.
Instructions for connecting station valves to controller output leads, including wire nut usage and station capacity.
Procedure for connecting a master valve to the controller, including common leads and caution for unused master valves.
Details for connecting 120V AC supply to the controller's transformer, including wiring diagrams.
Procedure to verify proper operation of control valves after installation, using the station dial and timing controls.
Instructions for setting the correct time and day on the controller using the MODE switch and dials.
Steps to set watering schedules by pushing pins on the HOUR and DAY dials for desired times and days.
General| Brand | Rain Bird |
|---|---|
| Model | RC-7A |
| Category | Controller |
| Language | English |
To Next Page