Do you have a question about the Rain Bird EASY RAIN and is the answer not in the manual?
Install a 9-volt alkaline battery, sealing connector terminals with grease for water protection.
Turn dial to RESET PGM, wait 10 seconds, then follow steps C, D, E for programming.
Select watering delay (0-12 hours). Turn dial, wait 10 seconds. +0 starts watering in 7 seconds.
Set watering frequency (24/48/72 hrs) and waterings per cycle (1X/2X). Turn dial, wait 10 seconds.
Choose watering duration (2, 5, 10, 15, 30, 60, 90 mins). Leave dial set for automatic operation.
Hand-screw solenoid onto the valve, then attach the Easy Rain unit to the solenoid.
Turn dial to OFF to stop watering. Return to selected run time (Step E) to resume operation.
Turn dial to ON for manual watering cycle. Starts in 10 seconds. Return to Step E setting for auto-op.
Install a 9-volt alkaline battery, sealing connector terminals with grease for water protection.
Turn dial to RESET PGM, wait 10 seconds, then follow steps C, D, E for programming.
Select watering delay (0-12 hours). Turn dial, wait 10 seconds. +0 starts watering in 7 seconds.
Set watering frequency (24/48/72 hrs) and waterings per cycle (1X/2X). Turn dial, wait 10 seconds.
Choose watering duration (2, 5, 10, 15, 30, 60, 90 mins). Leave dial set for automatic operation.
Hand-screw solenoid onto the valve, then attach the Easy Rain unit to the solenoid.
Turn dial to OFF to stop watering. Return to selected run time (Step E) to resume operation.
Turn dial to ON for manual watering cycle. Starts in 10 seconds. Return to Step E setting for auto-op.
| Brand | Rain Bird |
|---|---|
| Model | EASY RAIN |
| Category | Controller |
| Language | English |












Loading...