Pro2-Series 3D Printer
/ Quick Start Guide
B. Hardware Installation (continued)
Open the front door, and remove the
starter box and filament box from the base
of the printer.
Open these packages, and compare with
the following contents list.
7
Once the unit has been powered, the
printer will go through a start-up sequence.
Your Raise3D printer will take approximate-
ly 60 seconds to boot up. When the touch
screen displays the "Home" screen, the
printer is ready.
5
Open the "Utilities" tab, and press the Z
Homing button.
OK the request, and the print bed will
begin to “home” or move to the origin
position.
This will also allow you to access your
accessory packages.
6
01 02
03 04 05 06
07 08 09 10
11 12 13 14
15 16 17 18
19 20 21 22
23 2624 25
To Next Page
Loading...
