RAISE 3D Pro2 Series - Feed and Load Filament

Pro2-Series 3D Printer / Quick Start Guide
B. Hardware Installation (continued)
Locate the open end of the filament, and
feed it through the guide tube.
15
Press the “Utilities” tab on the screen and
set the temperature of the left nozzle for
the filament that you're using.
Press the “Load” button and the printer will
begin to heat. When the target tempera-
ture is reached, press "Load". Complete
the feeding operation according to the
instructions on the screen.
NOTE: This document's instructions are based on
the properties of Raise3D PLA filament. This is
the standard filament included with your product
and it is advised to use the Raise3D PLA for
testing and initial setup.
16
01 02
03 04 05 06
07 08 09 10
11 12 13 14
15 16 17 18
19 20 21 22
23 2624 25