Raise3D PRO2 Series - D. ideaMaker Initial Settings; Step 1: Select Printer Model; Step 2: Select Filament Diameter

Pro2-Series 3D Printer / Quick Start Guide
D. ideaMaker Initial Settings
When launching ideaMaker for the first time you, you will need to select your printer model from
the drop-down list, then press "Next".
1
Select the diameter of your filament. Press "Finish" to finalize the initial settings.
NOTE: ALL Pro2-Series printers use 1.75mm filaments.
2
01 02
03 04 05 06
07 08 09 10
11
12 13 14
15 16 17 18
19 20 21 22
23 2624 25
27