Raisecom ISCOM2624G-4C-PWR-AC - Ethernet Cable; Figure 6-2 Ethernet Cable; Table 6-3 Wiring of EIA;TIA 568 A and EIA;TIA 568 B Standards

Raisecom
ISCOM2600G (A) Series Product Description
6 Appendix
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
67
Wiring
Optical interface on
local device
Direction of optical
signals
Optical interface on
peer device
Dual-fiber
wiring
Tx optical interface
->
Rx optical interface
Rx optical interface
<-
Tx optical interface
6.1.2 Ethernet cable
Introduction
The Ethernet cable connects the Ethernet electrical interface and SFP electrical interface on
the ISCOM2600G series switch.
The Ethernet interface on the ISCOM2600G series switch is adaptive to straight-through
cable mode and crossover cable mode.
Appearance
Figure 6-2 shows the Ethernet cable.
Figure 6-2 Ethernet cable
Technical specifications
The Ethernet cables are divided into two types:

Straight-through cable: used to connect devices of different type, such as between a PC
and a switch, or between a switch and a router

Crossover cable: used to connect devices of the same type, such as between PCs,
between switches, between routers, or between a PC and a router (they are of the same
type)
Table 6-3 lists wiring of EIA/TIA 568A and EIA/TIA 568B standards.
Table 6-3 Wiring of EIA/TIA 568A and EIA/TIA 568B standards
Connector (RJ45)
EIA/TIA 568A
EIA/TIA 568B
PIN 1
White/Green
White/Orange
PIN 2
Green
Orange
PIN 3
White/Orange
White/Green
PIN 4
Blue
Blue