Need help?Do you have a question about the Raisecom ISCOM2126 and is the answer not in the manual?
General| Model | ISCOM2126 |
|---|---|
| Layer | Layer 2 |
| Switching Capacity | 8.8 Gbps |
| Forwarding Rate | 6.55 Mpps |
| MAC Address Table | 8K |
| VLAN | Yes |
| VLANs | 4K |
| Jumbo Frame | 9K |
| Storage Temperature | -40°C to 70°C |
| Weight | 2.5 kg |
| Type | Managed Switch |
| Ports | 24x 10/100Base-TX, 2x 1000Base-X SFP |
| Power Supply | AC: 100-240V, 50/60Hz |
| Operating Temperature | 0°C to 45°C |
| Operating Humidity | 10% to 90% non-condensing |
Details warranty terms for Raisecom products and replacement parts.
States that unauthorized reproduction or translation of the document is prohibited.
Confirms copyright ownership and prohibits unauthorized use of the publication.
Lists trademarks owned by Raisecom and other companies.
Provides methods to contact Raisecom for technical assistance.
Offers the URL to access current Raisecom product information.
Instructions for submitting comments and questions about the NView iEMS system.
Identifies the target audience for this user manual.
Lists other relevant manuals for Raisecom products.
Outlines the structure and content of the ISCOM2126 EMS User Manual.
Lists MIB standards supported by the ISCOM2126 EMS.
Describes the management capabilities of ISCOM2126 EMS using SNMP.
Configures Layer-2 port settings like speed, duplex, and PVID.
Configures Quality of Service parameters for traffic prioritization.
Manages VLAN settings for network segmentation and isolation.
Configures Spanning Tree Protocol to prevent network loops.
Saves the current switch configuration settings.
Describes how to view and manage active alarms on the EMS.
Explains how to view and analyze past alarm records.
To Next Page