Code Firmware Upgrade Codes (1*)
147 The configured countries are not consistent
151 Pre-manufacturing install process failed
152 Firmware install failed
153 Post-manufacturing install process failed
154 The autorun is missing required symbols
155 GSC firmware update failed
Code Diagnostic Codes (2*)
21
Recovery log detected. To clear this message, please take a diagnostic snapshot and upload
to https://secure.rajant.com.
22
Internal error detected. Please take a diagnostic snapshot and upload to
https//secure.rajant.com. This message will be cleared on the next reboot.
23 Internal developer settings detected - may cause undefined behavior. Use zeroize to clear.
233
This device is not configured for commercial use and will cause undefined behavior. Contact
support to rectify.
234 This device is running BETA soware. Contact support for the latest supported version.
24 Stress mode is running - may cause undefined behavior. Reboot to clear.
242
Internal hardware error detected via stress testing. Take a diagnostic snapshot and upload
to https//secure.rajant.com for analysis.
25 Internal developer overrides detected.
Code Self-Test Codes (3*)
31 Hardware configuration not set. Factory initialization required.
311 Hardware error detected.
32 BreadCrumb has been zeroized.
321 BreadCrumb is being zeroized.
322 Breadcrumb is in Deployment Mode.
33 Radio(s) not detected.
331 Radio in MANUAL compliance mode is violating country regulation.
332 Spectrum Access not granted
333 Low Battery
334 Gas gauge not initialized. To initialize, please power off unit and fully charge.
335 Non-compliant radio configuration in use
37 Failed to configure ethernet port
38 Resetting radio due to error.
381 Noise floor threshold exceeded
382 Radar detection paused radio
383 Radio resumed from radar pause
385 Radio(s) failed to initialize
To Next Page
Loading...
Need help?
General
