UNI-VERS ELEVATOR INSTALL MANUAL - TABLE OF CONTENTS
TOC-1
Rev 1A – Oct. 2003
• SECTION 1 - SIT E PREPARATION AND SET UP.
• SECTION 2 - GUIDE RAILS AND CROSS BRACES.
• SECTION 3 - MOTORS AND RUNNING GEAR.
• SECTION 4 - CARRIAGE.
• SECTION 5 - SAFETIES.
• SECTION 6 - DOORS.
• SECTION 7 – DOORS LOCK OPERATOR CAMS.
• SECTION 8 – OVER SPEED GOVERNOR.
• APPENDIX A – INSTRUCT IONAL DRAWINGS
• UG089 – LIMIT SWITCH OPERATOR BRACKET LOCATIONS
• CONTROLLAYOUT (1-5) – ON-BOARD CONTROLLER LOCATION AND LAYOUT
• CLEARANCES – CARRIAGE AND MOT OR CLEARANCES
• APPENDIX B - MISCELLANEOUS SHOP DRAWINGS.
• UG135 - COUNTER WEIGHT ASSEMBLY
• AFCUG035 - GEAR BOX AND UPPER HORIZONTAL SUPPORT
• AFCUD101 - DOOR FRAME ASSEMBLY
• APPENDIX C - REQUIRED TOOLS FOR INSTALLATION.
To Next Page