SECTION 6 - DOORS
Page 6-1
Rev 1A – Oct. 2003
Bi-fold Doors
6.1
Install the doors and jambs so that they are flush with the inside of the shaftway. The carriage corner studs should
clear the inside of the shaft by 1 1/2 inches at the end of the carriage, the side of the carriage should clear the inside of
the shaft by 3 inches (FIG. 1). See Appendix A for more door details.
6.2
Install the carriage door trim as shown (FIG. 1).
NOTE:
See shop drawings for details of these items.
MATERIAL LIST PART #
1. Complete door frame assembly AFCUD101
2. Bi-fold door AFBUD001
3. Carriage floor *NOTE
4. Carriage corner stud (L section) FFBUC060
5. Floor finishing plate *NOTE
6. Entrance trim - guide rail side FEBUC071
7. Entrance trim - opp. guide rail side FEBUC072
Figure 1. Installing the door, jamb, and carriage door trim.
To Next Page
Loading...