37
4.7 Visualize date and pressure
Setting of the display visualization of date/time or
boiler pressure value.
4.11 Software version and date
The software update version is shown on the di-
splay.
4.8 Adjust boiler pressure
Adjustment of the boiler pressure values with value
increase of 0,05 bar.
4.9 ISTEAM functions
The temperature values and milk cream level are
set.
The following options are visualized:
For “whipped milk” the nal milk temperature can
be set (in °C / °F degrees) as well as the whipping
level ranging from 1 to 12.
Also for “non whipped milk” , in addition to the nal
temperature, a slight whipping can be set (ranging
from 1 to 12).
4.10 Align probes
Boiler temperature probe alignment
This function allows to carry out via software the ali-
gnment of the boiler temperature probes in relation
to a reference value.
The display shows the pressure measured by the
probe in real time and the corresponding alignment
value.
Make sure that the pressure read with a reference
manometer corresponds to the value read by the
probe.
Should the manometer show a higher or lower pres-
sure, correct with “+” or “-” buttons in order to carry
out the temperature control system alignment; press
“enter” to conrm.
To Next Page
Loading...
Need help?
General
