● Carry out cleaning and maintenance operations.
● Wind up the cable and fasten it to the machine
with sticky tape.
● Cover the machine and place it in a dry room. Do
not leave it exposed to atmospheric agents and
do not allow it to be touched by children or unift
persons.
To disconnect from the main power supply, consult
qualied personnel.
● Besides carrying out the operations necessary for
a temporary stop, cut off the cable, pack the ma-
chine in cardboard, polystyrene or other packing
material and consign it to rms authorized for its
disposal or to second-hand goods dealers.
Check operations to be carried out by the
user with the plug disconnected.
For any type of problem or inconvenience
not specically indicated, disconnect the
plug and contact our service centre without
attempting any direct repairs.
A) The machine does not start:
- check that the plug is connected;
- In case of power failure wait for the power to return
and check if the earth leakage protection circuit
breaker or the main switch is on;
- check the condition of the plug and the supply
cable; if damaged have them replaced by qualied
personnel.
B) There is water under the machine:
- check that the drainage tray is not obstructed.
C) Slow dispensing:
- check that the filters and delivery heads are
clean;
- check that the coffee is not too nely ground.
D) Irregular steam delivery:
- check that the nozzles are not obstructed.
Regenerate the water softener within the time-limi-
ts specied for the softener as follows:
nr.1 regeneration per month for 500 coffees/day;
nr.2 regenerations per month (once a fortnight) for
1000 coffees/day.
nr.1 regeneration per month for 1000 coffees/
day;
nr.2 regenerations per month (once a fortnight) for
2000 coffees/day.
This table has been drawn up according to a water har-
dness of 25 degress calculated on the French scale.
See the documentation included with the softener
for the instructions for use.
To Next Page
Loading...
Need help?
General
