R&S FSV3044 - Page 1015

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
1015User Manual 1178.8520.02 ─ 01
CALCulate<n>:MARKer<m>:FUNCtion:FPEaks:X?
This command queries the position of the peaks on the x-axis.
The order depends on the sort order that has been set with CALCulate<n>:
MARKer<m>:FUNCtion:FPEaks:SORT.
Suffix:
<n>
.
irrelevant
<m> irrelevant
Return values:
<PeakPosition> Position of the peaks on the x-axis. The unit depends on the
measurement.
Usage: Query only
CALCulate<n>:MARKer<m>:FUNCtion:FPEaks:Y?
This command queries the position of the peaks on the y-axis.
The order depends on the sort order that has been set with CALCulate<n>:
MARKer<m>:FUNCtion:FPEaks:SORT.
Suffix:
<n>
.
irrelevant
<m> irrelevant
Return values:
<PeakPosition> Position of the peaks on the y-axis. The unit depends on the
measurement.
Usage: Query only
14.8.3.9 Noise Measurement Marker
The following commands control the noise measurement marker function.
CALCulate<n>:MARKer<m>:FUNCtion:NOISe:AOFF...................................................... 1015
CALCulate<n>:MARKer<m>:FUNCtion:NOISe:RESult?...................................................1016
CALCulate<n>:MARKer<m>:FUNCtion:NOISe[:STATe]....................................................1016
CALCulate<n>:MARKer<m>:FUNCtion:NOISe:AOFF
Removes all noise markers in the specified window.
Suffix:
<n>
.
Window
<m> irrelevant
Example:
CALC:MARK:FUNC:NOIS:AOFF
Analyzing Measurements (Basics)