R&S FSV3044 - Page 957

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
957User Manual 1178.8520.02 ─ 01
Suffix:
<n>
.
Window
<w> subwindow
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
Example:
DISP:ZOOM ON
Activates the zoom mode.
Manual operation: See " Single Zoom " on page 421
See " Restore Original Display " on page 422
14.8.1.2
Using the Multiple Zoom
DISPlay[:WINDow<n>][:SUBWindow<w>]:ZOOM:MULTiple<zn>:AREA...............................957
DISPlay[:WINDow<n>][:SUBWindow<w>]:ZOOM:MULTiple<zn>[:STATe]............................ 958
DISPlay[:WINDow<n>][:SUBWindow<w>]:ZOOM:MULTiple<zn>:AREA
<x1>,<y1>,<x2>,<y2>
This command defines the zoom area for a multiple zoom.
To define a zoom area, you first have to turn the zoom on.
1
= origin of coordinate system (x1 = 0, y1 = 0)
2 = end point of system (x2 = 100, y2= 100)
3 = zoom area (e.g. x1 = 60, y1 = 30, x2 = 80, y2 = 75)
Suffix:
<n>
.
Window
<w> subwindow
<zn> Selects the zoom window.
Analyzing Measurements (Basics)