R&S NRT-Z14 - Legacy Setups

Preparing for use
R&S
®
NRT-Z14/44
18Getting Started 1443.8632.02 ─ 01
If the base unit does not recognize the power sensor, check the baud rate set-
ting.
See the user manual.
Further information:
●
Chapter 5.1, "Base unit", on page 23
●
User manual of the base unit
3.5.3 Legacy setups
To support legacy setups, you can also connect the power sensor to the following
legacy adapters and instruments:
●
R&S NRT‑Z3 interface adapter
To connect to a computer with standard RS-232 interface.
●
R&S NRT‑Z4 PCMCIA interface adapter
To connect to a computer with a PCMCIA type II slot.
●
R&S NRT
Legacy base unit
Connecting to a computer or base unit