R&S NRT-Z14 - Connecting to a Computer or Base Unit; Computer

Preparing for use
R&S
®
NRT-Z14/44
16Getting Started 1443.8632.02 ─ 01
To disconnect from the DUT
1. CAUTION! Risk of electric shock and severe skin burns. See "Connecting
directional power sensors" on page 6.
Switch off the RF power before touching the RF connectors.
2. Unscrew the RF connectors by hand.
3.5 Connecting to a computer or base unit
For connecting the power sensor to a computer or base unit, use the host inter-
face. See Chapter 4.2, "Host interface", on page 20.
For operating the power sensor, you can choose from various possibilities. For
details, see Chapter 5, "Operating concepts", on page 23.
3.5.1 Computer
As a controller, you can use a computer with a Microsoft Windows operating sys-
tem, equipped with R&S Virtual NRT or remote control software.
2
3
4
5
1
Figure 3-2: Connecting to computer
1 = R&S NRT‑Zxx directional power sensor
2 = host interface connector → sensor interface
3 = R&S NRT‑Z5 USB interface adapter
4 = USB connector → USB port
5 = computer
Connecting to a computer or base unit