R&S NRT-Z14 - Page 28

Operating concepts
R&S
®
NRT-Z14/44
28Getting Started 1443.8632.02 ─ 01
●
Interface parameters same as for power sensor, see "Power sensor interface
settings" on page 27.
●
ASCII configuration: end of transmitted lines with LF
Example: Using the PuTTY terminal program
This example shows the configuration of the PuTTY terminal program (https://
www.putty.org/).
1. Under "Session", configure as follows:
a) "Serial line": Must match the COM port that is assigned to the serial
adapter, usually R&S NRT‑Z5 USB interface adapter. You can look up this
information in the device manager of the operating system.
b) Speed: Must match the baud rate setting of the power sensor.
c) Connection type: "Serial"
2. If you want to reuse the session settings, you can save them:
a) Under "Saved Sessions", enter the name.
b) Click "Save".
c) To load a session, double-click the list entry.
3. Recommendation for "Terminal" settings: Set both "Local echo" and "Local
line editing" to "Force on". This way, you can see your input and edit the input
line.
Remote control