R&S RTO - Page 567

Remote Control
R&S
®
RTO
551User Manual 1316.0827.02 ─ 06
MEASurement<m>:EYEJitter:LCHeck<n>:VALid <ValidRange>
Enables or disables limit checking for eye/jitter measurements in the specified measure-
ment channel.
Suffix:
<m>
.
1..9
See "Measurement selection: MEASurement<m>" on page 522.
<n> 1..30
Number of eye/jitter measurement type, see table 16-15.
Parameters:
<ValidRange> ILIMit | ULIMit | LLIMit | OLIMit
ILIMit
Inside (within) limit; between the upper and lower limit values
ULIMit
Upper limit; above the upper limit value
LLIMit
Lower limit; below the lower limit value
OLIMit
Outside limit; above the upper limit or below the lower limit values
*RST: ILIMit
MEASurement<m>:EYEJitter:LCHeck<n>:LOWer:LIMit <LowerLimit>
MEASurement<m>:EYEJitter:LCHeck<n>:UPPer:LIMit <UpperLimit>
Define the lower and upper limit for the limit check, respectively. The valid range is defined
using the MEASurement<m>:EYEJitter:LCHeck<n>:VALid command.
Suffix:
<m>
.
1..9
See "Measurement selection: MEASurement<m>" on page 522.
<n> 1..30
Number of eye/jitter measurement type, see table 16-15.
Parameters:
<LowerLimit>
<UpperLimit>
Range: -100 to 100
Increment: 10E-6
*RST: 0
MEASurement<m>:EYEJitter:LCHeck<n>:LOWer:MARGin <LowerMargin>
MEASurement<m>:EYEJitter:LCHeck<n>:UPPer:MARGin <UpperMargin>
Defines the upper margin for the limit check. Margins are not as strict as limits and must
be within the valid value range. The valid range is defined using the 
MEASurement<m>:EYEJitter:LCHeck<n>:VALid command.
Command Reference