R&S RTO - Page 636

Remote Control
R&S
®
RTO
620User Manual 1316.0827.02 ─ 06
SEARch:TRIGger:INTerval:RANGe <SearchName>,<RangeMode>
SEARch:TRIGger:INTerval:RANGe? <SearchName>
Selects how the range of an interval is defined based on the interval width and delta (see
SEARch:TRIGger:INTerval:WIDTh on page 620 and SEARch:TRIGger:
INTerval:DELTa on page 619).
Parameters:
<RangeMode> WITHin | OUTSide | SHORter | LONGer
WITHin
Triggers on pulse intervals inside a given range. The range is
defined by "Interv. width" and "±Delta".
OUTSide
Triggers on intervals outside a given range. The range definition
is the same as for "Within" range.
SHORter
Triggers on intervals shorter than the given "Interv. width".
LONGer
Triggers on intervals longer than the given "Interv. width".
*RST:
OUTSide
Parameters for setting and query:
<SearchName> Search definition
Usage: SCPI confirmed
SEARch:TRIGger:INTerval:WIDTh <SearchName>,<Width>
SEARch:TRIGger:INTerval:WIDTh? <SearchName>
Defines the time between two pulses.
Parameters:
<Width> Range: 100E-12 to 864
Increment: 100E-9
*RST: 5E-9
Default unit: s
Parameters for setting and query:
<SearchName> Search definition
Usage: SCPI confirmed
Runt
SEARch:TRIGger:RUNT:DELTa......................................................................................621
SEARch:TRIGger:RUNT:POLarity...................................................................................621
SEARch:TRIGger:RUNT:RANGe.....................................................................................621
SEARch:TRIGger:RUNT:WIDTh......................................................................................622
SEARch:TRIGger:LEVel:RUNT:LOWer............................................................................622
SEARch:TRIGger:LEVel:RUNT:UPPer.............................................................................623
Command Reference