R&S RTO6 - Rohde & Schwarz Smartgrid

Operating the instrument
R&S
®
RTO6
50Getting Started 1801.6670.02 ─ 03
To arrange a waveform using the SmartGrid
See Chapter 6.5, "Rohde & Schwarz smartgrid", on page 50.
To switch off a waveform
► Do one of the following:
● To switch off a minimized waveform, tap the "Close" icon in the upper right
corner of the minimized signal view.
● Disable "Channel" in the "Vertical" > "Setup" tab.
● Tap the "Delete" icon (Recycle bin) in the toolbar, and then the waveform.
If several waveforms overlap or lie close together, the upper (selected)
waveform is switched off.
6.5 Rohde & Schwarz smartgrid
The Rohde & Schwarz SmartGrid helps to create and arrange the diagrams on
the screen with drag&drop. The diagram layout depends on the position where
you drop the signal icon, in relation to an existing diagram.
Figure 6-7: SmartGrid positions
1 = In the existing diagram, overlay of signal
2 = New diagram on the left or right
3 = New diagram above or below
4 = New diagram on top of the existing diagram
5 = XY-diagram
6 = YX-diagram
Rohde & Schwarz smartgrid