R&S ZNA26 - Page 1440

Command reference
R&S
®
ZNA
1440User Manual 1178.6462.02 ─ 20
Suffix:
<PhyPt>
.
Physical port number
Parameters:
<Active>
Options: R&S ZNA-K8
Manual operation: See "Power Control" on page 834
SOURce:POWer<PhyPt>:CORRection:SLEVeling[:ACQuire]
Starts the leveling data acquisition at port <PhyPt>.
Define the leveling grid using
SOURce<Ch>:POWer<PhyPt>:CORRection:SLEVeling:FREQuency and
SOURce<Ch>:POWer<PhyPt>:CORRection:SLEVeling:POWer commands.
Suffix:
<PhyPt>
.
Physical port number
Example: Suppose we have configured a setup with two converters ZVA-
Z110.
SOURce:POWer:CORRection:SLEVeling:FREQuency:STARt 75 GHz
SOURce:POWer:CORRection:SLEVeling:FREQuency:STOP 110 GHz
SOURce:POWer:CORRection:SLEVeling:FREQuency:POINts 101
SOURce:POWer:CORRection:SLEVeling:POWer:STARt -25
SOURce:POWer:CORRection:SLEVeling:POWer:STOP 0
SOURce:POWer:CORRection:SLEVeling:POWer:STEP 0.5 DB
SOURce:POWer:CORRection:SLEVeling:POWer:ALC ON
SOURce:POWer1:CORRection:SLEVeling:ACQuire
Usage: Event
Options: R&S ZNA-K8
Manual operation: See "Start Cal Sweep" on page 550
SOURce:POWer:CORRection...
The SOURce:POWer:CORRection... commands control a scalar source power cali-
bration.
SOURce:POWer:CORRection:PMETer:ID...................................................................... 1441
SOURce:POWer<PhyPt>:CORRection:SLEVeling:DELete............................................... 1441
SOURce<Ch>:POWer:CORRection:DATA......................................................................1442
SOURce<Ch>:POWer:CORRection:DATA:PORT<PhyPt>................................................1442
SOURce<Ch>:POWer:CORRection:DATA:PARameter<Wv>?.......................................... 1443
SOURce<Ch>:POWer<PhyPt>:CORRection:HARMonic[:ACQuire]................................... 1443
SOURce<Ch>:POWer:CORRection:IMODulation:PORT.................................................. 1444
SOURce<Ch>:POWer<PhyPt>:CORRection[:ACQuire]................................................... 1445
SOURce<Ch>:POWer<PhyPt>:CORRection[:ACQuire]:VERification:RESult?.................... 1446
SOURce<Ch>:POWer<PhyPt>:CORRection:COLLect:AVERage[:COUNt].........................1447
SOURce<Ch>:POWer<PhyPt>:CORRection:COLLect:AVERage:NTOLerance...................1447
SCPI command reference