R&S ZNA26 - Page 1456

Command reference
R&S
®
ZNA
1456User Manual 1178.6462.02 ─ 20
SOURce:POWer:CORRection:PPOWer <RecCalPower>
Defines the source power the R&S ZNA uses to perform the first calibration sweep of
the source power calibration ("Reference Receiver Cal Power"). This predefined power
value is ignored if the R&S ZNA is set to use the calculated port power result
(SOURce<Ch>:POWer<PhyPt>:CORRection:PSELect CPOW).
Parameters:
<RecCalPower> Reference receiver cal power
Range: Depending on source power range of the analyzer
and the power range of the external power meter.
*RST: 0 dBm
Default unit: dBm
Example: See SOURce<Ch>:POWer<PhyPt>:CORRection[:ACQuire]
.
Manual operation: See "Reference Receiver Cal Power" on page 576
SOURce:POWer:CORRection:PPOWer:PATTenuation <SrcAtt>
Defines the source step attenuation the R&S ZNA uses during the first calibration
sweep of the source power calibration ("Reference Receiver Cal Power"). This attenu-
ation value is ignored if the R&S ZNA is set to use the calculated port power result
(SOURce<Ch>:POWer<PhyPt>:CORRection:PSELect CPOW).
Parameters:
<SrcAtt> Attennuation value
Range: 0 to 70 dB
Increment: 10 dB
*RST: 0 dB
Default unit: dB
Manual operation: See "Reference Receiver Cal Power" on page 576
SOURce<Ch>:POWer<PhyPt>:CORRection:PSELect <CalPower>
Qualifies how to define the source power the R&S ZNA uses to perform the first cali-
bration sweep of the source power calibration ("Reference Receiver Cal Power").
Suffix:
<Ch>
.
Calibrated channel number. This parameter is ignored; this set-
ting applies to all channels.
<PhyPt> Calibrated port number. This parameter is ignored; this setting
applies to all channels.
Parameters:
<CalPower> CPOWer | PPOWer
CPOWer
Calculated port power result
SCPI command reference