R&S ZNA26 - Page 1523

Command reference
R&S
®
ZNA
1523User Manual 1178.6462.02 ─ 20
TRIGger[:SEQuence]:LTRigger:COUNt?........................................................................ 1524
TRIGger[:SEQuence]:LTRigger:RESet........................................................................... 1525
TRIGger<Ch>[:SEQuence]:MULTiple:HOLDoff................................................................1525
TRIGger<Ch>[:SEQuence]:MULTiple:LOGic...................................................................1525
TRIGger<Ch>[:SEQuence]:MULTiple:SLOPe<Num>....................................................... 1526
TRIGger<Ch>[:SEQuence]:MULTiple:SOURce<inp>....................................................... 1526
TRIGger<Ch>[:SEQuence]:SLOPe................................................................................ 1527
TRIGger<Ch>[:SEQuence]:SOURce..............................................................................1528
TRIGger<Ch>[:SEQuence]:EINPut <TrigExtInput>
In external trigger mode (TRIGger<Ch>[:SEQuence]:SOURce EXTernal), this
command selects one of the available external trigger sources.
Suffix:
<Ch>
.
Parameters:
<TrigExtInput> EXTA | EXTB | EXTC | EXTD | UPORt2
EXTA
Trigger In A or Pin 2 of User Port
EXTB | EXTC | EXTD
Trigger In B, ..., Trigger In D
(requires Trigger board option R&S ZNA-K91)
UPORt2
Pin 25 of User Port
Manual operation: See "Source" on page 507
TRIGger<Ch>[:SEQuence]:HOLDoff <DelayTime>
Sets a delay time between the trigger event and the start of the measurement ("Trigger
Delay").
Suffix:
<Ch>
.
Channel number.
Parameters:
<DelayTime> Delay time.
Range: 0 s to 13680 s
Increment: 10 ms
*RST: 0 s
Default unit: s
Example:
TRIG:SOUR MAN
Activate external trigger source.
TRIG:HOLD UP
Set a delay time of 10 ms.
Manual operation: See "Delay" on page 507
SCPI command reference