R&S ZNA26 - Page 1538

Command reference
R&S
®
ZNA
1538User Manual 1178.6462.02 ─ 20
[SENSe<Ch>:]FREQuency:MDELay:LTONe <lower tone port number>
Suffix:
<Ch>
.
Parameters:
<lower tone port
number>
Manual operation: See "Lower Tone" on page 373
[SENSe<Ch>:]FREQuency:MDELay:RECeiver
<Group Delay Receiver Mode>
Suffix:
<Ch>
.
Parameters:
<Group Delay
Receiver Mode>
INTernal | EXTernal
[SENSe<Ch>:]FREQuency:MDELay:RPORt <receiver port number>
Suffix:
<Ch>
.
Parameters:
<receiver port
number>
Manual operation: See "IF" on page 373
[SENSe<Ch>:]FREQuency:MDELay:UTONe <Upper tone source signal>[, <port
number>]
Selects the source for the upper tone signal that is used for the mixer delay measure-
ment.
Suffix:
<Ch>
.
Channel number.
Parameters:
<Upper tone source
signal>
PORT | GENerator | NONE
Upper tone source:
NONE – no source selected
PORT – internal source at port <source_no>
GENerator – external generator no. <source_no>, as defined in
the System Configuration – External Generators dialog
Range: 1 to port number of the analyzer/number of external
generators
<port number> Number of the port for the internal source or of the generator (to
be omitted for source NONE)
SCPI command reference