GUI reference
R&S
®
ZNA
373User Manual 1178.6462.02 ─ 20
Lower Tone
Select the port that generates the lower tone of the two-tone signal.
Remote command:
[SENSe<Ch>:]FREQuency:MDELay:LTONe
Lower Tone
Select the port that generates the upper tone of the two-tone signal.
Remote command:
[SENSe<Ch>:]FREQuency:MDELay:UTONe
IF
Select the receive port for the two-tone group delay measurement.
Remote command:
[SENSe<Ch>:]FREQuency:MDELay:RPORt
Delta Frequency
Selects the frequency delta between upper tone and lower tone.
Remote command:
[SENSe<Ch>:]FREQuency:MDELay:APERture
Apply/OK
Applies the settings and activates the group delay measurement mode for the channel
selected in the title bar of the setup dialog.
Meas softtool
To Next Page
Loading...
