R&S ZNA26 - Page 1562

Command reference
R&S
®
ZNA
1562User Manual 1178.6462.02 ─ 20
●
all data with DIAG:HUMS:DEL:ALL
Example: //Delete complete utilization history
DIAG:HUMS:UTIL:HIST:DEL:ALL
Usage: Event
7.4.5 Service date commands
Using these commands you can get and set instrument service dates.
These dates are part of the R&S HUMS information, but do not require software option
R&S ZNA-980.
DIAGnostic:SERVice:CALibration:DATE......................................................................... 1562
DIAGnostic:SERVice:CALibration:DUE:DATE................................................................. 1562
DIAGnostic:SERVice:CALibration:DUE:STATe?...............................................................1563
DIAGnostic:SERVice:CALibration:INTerval?....................................................................1563
DIAGnostic:SERVice:DATE...........................................................................................1563
DIAGnostic:SERVice:STATe?........................................................................................ 1563
DIAGnostic:SERVice:CALibration:DATE <CalibrationDate>
This command sets last date and time the instrument was calibrated in ISO 8601 for-
mat.
Parameters:
<CalibrationDate> String containing calibration date of the instrument.
Example: //Set calibration date
DIAG:SERV:CAL:DATE "2019-05-05T00:00:00Z"
Manual operation: See "Last Calibration" on page 810
DIAGnostic:SERVice:CALibration:DUE:DATE <DueDate>
This command sets next date and time the instrument needs calibration to be done in
ISO 8601 format. The response may be empty in case of no fixed next calibration due.
Parameters:
<DueDate> String containing next calibration due date.
An empty string resets the date (= no due date).
Example: //Set calibration due date
DIAG:SERV:CAL:DUE:DATE "2020-05-12T00:00:00Z"
Manual operation: See "Next Calibration Due" on page 810
HUMS and service date commands