R&S ZNA26 - Page 810

GUI reference
R&S
®
ZNA
810User Manual 1178.6462.02 ─ 20
Remote command:
TRIGger[:SEQuence]:LTRigger[:STATe]
Service Tab
Allows you to read or specify service-related information. This information can be read
via R&S HUMS, however, it does not require the corresponding option R&S ZNA-K980.
Next Calibration Due
The date (and time) the instrument needs calibration to be done.
Remote command:
DIAGnostic:SERVice:CALibration:DUE:DATE
Recommended Calibration Interval
Queries the recommended calibration interval, set by Rohde&Schwarz service.
Remote command:
DIAGnostic:SERVice:CALibration:INTerval?
Last Service
The last date (and time) the instrument was serviced.
Typically set by Rohde&Schwarz service.
Remote command:
DIAGnostic:SERVice:DATE
Last Calibration
The last date (and time) the instrument was calibrated.
Typically set by Rohde&Schwarz service.
Remote command:
DIAGnostic:SERVice:CALibration:DATE
5.19.1.4 Service Function dialog
The "Service Function" dialog gives access to the service functions of the instrument.
Access: [Setup] > "Setup" > "Service Function..."
Setup softtool