R&S ZNA26 - Page 501

GUI reference
R&S
®
ZNA
501User Manual 1178.6462.02 ─ 20
●
"Delete All" clears the entire segment list so it is possible to define or load a new
segmented sweep range.
Remote command:
[SENSe<Ch>:]SEGMent<Seg>:ADD
[SENSe<Ch>:]SEGMent<Seg>:INSert
[SENSe<Ch>:]SEGMent<Seg>:DELete[:DUMMy]
[SENSe<Ch>:]SEGMent<Seg>:DELete:ALL
Show Point List...
Opens a list of all active sweep points and their channel settings. All columns except
"Point", "Segment" and "Frequency" are displayed only if they are explicitly selected;
see "Displayed Columns dialog" on page 502.
Figure 5-18: Point List
Import.../ Export...
The buttons open standard dialogs to import/export sweep segment settings to/from an
ASCII file (*.SegList).
●
"Import..." replaces the current segment list by a sweep segment list loaded from a
*.SegList file.
●
"Export..." stores the current sweep segments settings to a *.SegList file.
Sweep segment files
The analyzer uses a simple ASCII format to export sweep segment data. By default,
the sweep segment file extension is *.SegList. The file starts with two comment
lines containing the version and a third line reproducing the header of the segment list.
The following lines contain the entries of all columns of the segment list, including the
"Displayed Columns" that ae configured in the "Define Segments" dialog.
Sweep Softtool