R&S ZNA26 - Page 645

GUI reference
R&S
®
ZNA
645User Manual 1178.6462.02 ─ 20
Sync Meas to Pulse Gen.
Allows you to switch between synchronous and asynchronous measurement.
Remote command:
[SENSe<Ch>:]PULSe:SYNCron[:STATe]
Autoset
Adjusts "Acq. Delay" and "Acq. Time" according to the configured pulses.
5.13.2.3 VSE Connection Configuration dialog
The controls on the "VSE Connection Configuration" dialog allow you to set up and
establish a connection to a local or remote R&S VSE instance.
For background information, see Chapter 4.7.6.1, "Live pulse analysis with R&S VSE",
on page 251.
Access: Pulse Mod tab > "Configure VSE"
Start/Connect VSE / Disconnect VSE
Select your target R&S VSE using Local VSE or the VISA address list. Then use the
"Start/Connect VSE" button to connect to it and to start its pulse measurements appli-
cation (R&S VSE-K6 ). A local R&S VSE is started automatically.
Once the connection is established, you can use "Disconnect VSE" to terminate it.
Remote command:
CONTrol:VSE:CONNect
CONTrol:VSE:DISConnect
Local VSE
Tells the R&S ZNA that you want to connect to a local R&S VSE. Use Start/Connect
VSE / Disconnect VSE to establish the connection.
Mode softtool